匈牙利品牌FAKOPP 用于测量躯干的产物木材应力波微秒计Microsecond Timer-蜜桃91一区二区三区

产物分类

products category

技术文章/ article

您的位置：首页 - 技术文章 - 匈牙利品牌FAKOPP 用于测量躯干的产物木材应力波微秒计Microsecond Timer

匈牙利品牌FAKOPP 用于测量躯干的产物木材应力波微秒计Microsecond Timer

更新时间：2024-04-11&苍产蝉辫;&苍产蝉辫;&苍产蝉辫;&苍产蝉辫;&苍产蝉辫;&苍产蝉辫;

浏览次数：302

匈牙利品牌FAKOPP 用于测量躯干的产物木材应力波微秒计Microsecond Timer

以微秒为单位测量传输时间

非常快

一天中甚至可以测量100棵树

探测更大的衰变，空穴

Measures the transit time in microseconds

Very fast

Even a 100 trees can be measured during one day

Detects the bigger decays, holes

Fakopp Microsecond Timer

Connect the transducers to the timer box.
Switch on the timer. Before each hit please press the
“Reset" button. If you want to use the auto reset function,
switch on the timer while the “Reset" button is held down.
In this case the actual readout appears on the screen after
each hit without pressing “Reset".
Transducers are identical. Please select the transducer, connected
to the ?Start" connector. A colour mark helps you to identify the
start transducer. Hit the start sensor by using hammer. The hit
should always be parallel with the direction of the nail. Use a rubber
hammer for driving in the sensors. For the measurement use a 100 g
steel hammer. Let the hammer spring back. After use, switch off the unit.
将传感器连接到计时器盒。打开计时器。每次点击前请按下“重置"按钮。
如果您想使用自动重置功能，请在按住“重置"按钮的同时打开计时器。
在这种情况下，实际读数会在每次点击后出现在屏幕上，而无需按下“重置"。
传感器是相同的。请选择连接到“启动"连接器的传感器。彩色标记有助于
识别启动传感器。用锤子敲击起动传感器。击打方向应始终与钉子的方向平行。
使用橡胶锤敲入传感器。使用100克钢锤进行测量。让锤子的弹的回来。使用后，
请关闭设备。